Rangemaster RDW945FI manual Fitting the Decor Door, Fixing the door panel fittings

The adjustable feet allow the dishwasher to be raised up to 870 mm. If the space between the floor and the underside of the work surface is more than 870 mm, the unit should be positioned on suitable wooded spacers that should be fixed to the floor (Fig.5-5).

Always use a spirit level to make sure that the appliance is level left-to-right and front-to-back. If the appliance is installed on carpet, ensure that there is clearance beneath the appliance.

Adjust the feet to raise and level the dishwasher to the correct height (Fig.5-6). Using the tool supplied, adjust the rear feet via the studs ‘A’ at the front of the appliance. Adjust the front feet ‘B’ using the spanner provided.

To prevent damage to the floor surface, install the appliance on the plastic skids supplied.

Fitting the Decor Door

Fixing the door panel fittings

Place the template supplied on the back face of the door panel. Align the top of the template, as identified by the ‘A’ arrow, with the top of the door and align the side of the template with the left-hand edge of the door (Fig.5-7). Using a pencil or bradawl, mark the positions of the holes closest the door panel edge.

Repeat this step for the right-hand side of the door panel using the other side of the template.

Align a mounting bracket with the two marks on the lower left-hand part of the panel. Mark the remaining hole in the top of the bracket (Fig.5-8)and then remove. Repeat for the other side.

At the points marked, carefully drill 2mm holes to a maximum depth of 10mm. Take care not to drill through to the front face of the door panel.

Position the two brackets on the panel, with the tab facing downwards. Using the screws supplied, fix the brackets to the panel.

Secure the two plastic hooks to the holes at the top of the

panel (Fig.5-9).

Mounting the door panel to the dishwasher

Insert the top plastic hooks into the slots on the dishwasher front ‘A’. Carefully slide the panel up the channels until it stops. Slide the panel downwards ‘B’, moving the bottom of the panel door so that the bracket tabs locate into the slots in the dishwasher front (Fig.5-10).

Align the top of the door panel with the adjacent cabinets. Gently open the dishwasher door while supporting the door panel. Secure the door panel using the screws supplied (Fig.5-11). Cover the screw heads using the plastic caps provided.

Note: If you have difficulties fitting the door (for example, if doors are already fitted to adjoining cabinets) then pull the dishwasher out slightly to allow for easier access for the door tabs. With the door fitted, push the appliance back into position.

Fig.5-8

ArtNo.800-0111 - Marking the plate position

Fig.5-9

ArtNo.800-0105 - Fitting the plastic hooks

Fig.5-10

�

�

ArtNo.800-0106 - Fitting the door

Fig.5-11

ArtNo.800-0107 - Securing the door

17