Electrical Connections, Hotplate, Customer Care

INSTALLATION

Check the appliance is electrically safe and gas sound when you have ﬁnished.

Electrical Connections

This appliance must be installed by a qualiﬁed electrician to comply with the relevant Institute of Electrical Engineers (I.E.E.) regulations and also the local electricity supply company requirements.

WARNING: THIS APPLIANCE MUST BE EARTHED

Note: All external wiring must comply with the IEE Regulations for the Electrical Equipment of Buildings. Connection to the electrical supply can be made with either a plug and socket, or be permanently wired via a double pole switch. The hob is supplied with a 3-core cable, 900mm long.

If a replacement cable is ﬁtted it must be 250V high temperature PVC (85°C), 1 mm² minimum conductor size.

Plug Connection

For a plug connection a three-pin plug to BS 1363 with a capacity of not less than 13A must be used and ﬁtted with a 3A fuse, ‘ASTA’ approved to BS 1362.

After replacing the fuse the cover must be reﬁtted. If the cover is lost, the plug must not be used until a replacement cover has been obtained from your supplier. The colour of the correct fuse carrier is that of the coloured insert in the base of the fuse recess, or stated elsewhere on the plug. Always state this colour when ordering a replacement fuse carrier.

IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:

Green and yellow: Earth

	Fig.5-4
	��
��
	��
��
��	��
	��
	��
��
	��

��

Blue:Neutral

Brown:Live

Hotplate

Check each burner in turn. There is a spark ignition system that works when the knob is pressed in. Each burner also has a special safety device that stops the ﬂow of gas if the ﬂame goes out.

Push in and turn a control knob to the large ﬂame symbol [].

Keep holding the knob pressed in to let the gas through to the burner for few seconds. The igniter should spark and light the gas.

If, when you let go of the control knob, the burner goes out, the safety device has not held in. Turn the control to the oﬀ position and wait one minute, then try again this time holding in the control knob for slightly longer.

Customer Care

Please complete your contact details in the front of this section. Please inform the user how to operate the hotplate and hand over the instruction pack.

Rangemaster RGG77 Electrical Connections, Hotplate, Customer Care, Plug Connection, Thank you

Models: RGG77