Changing the plug (UK)
This appliance comes fitted with a 13amp plug fitted. Should you need to replace the fuse, a 13amp ASTA approved
(BS 1362) must be used. Should the plug itself need to be replaced, the wires in the mains lead are coloured in accordance with the following code:
Green and yellow = Earth
Blue = Neutral
Brown = Live
Earth - Yellow/Green
Live - Brown
Neutral - Blue
Wiring of a standard 13 amp British three- pin plug
The wire coloured green and yellow must be connected to terminal marked with the letter E, coloured green and yellow or marked with the earth symbol:
The wire coloured blue must be connected to the terminal marked with the letter N, or coloured blue.
The wire coloured brown must be connected to the terminal marked with the letter L or coloured brown.
Upon completion, there must be no cut or stray wire present and the cord clamp must be secure over the outer sheath.
Changing the light bulb
Before replacing the light bulb, switch off the electricity supply to the appliance and unplug the appliance.
Lamp required: 220 – 240V~25W (fridge only)
Lamp required: 220 – 240V~40W (freezer only)
Lamp holder: E27 (Do not exceed the wattage given for lamps)
To replace the lamp;
1.Pull the lampshade towards you.
2.Hold up (1) and pull out (2) the lampshade.
3.Rotate the lamp anticlockwise until the lamp is released.
4.Always replace the bulb with one that is identical.
Bulbs are not covered by any warranty, but can be purchased at your local hardware store. Remember to take the old bulb with you if you are unsure of what kind of bulb to buy.
15
