Electrical Connection, Hob Check, Grill Check

clockwise to raise the cooker and anticlockwise to lower.

When you are satisﬁed with the height and level, raise the front of the cooker by one turn of the front roller adjuster. Screw down the front feet to meet the ﬂoor. Screw the front roller adjuster anticlockwise to raise the front roller so that the front of the cooker is supported on the feet, not the front roller, to prevent accidental movement of the cooker.

Leave the levelling tool on the adjuster with the handle of the tool facing the rear of the cooker, so that the customer can use it if they wish to move the cooker.

Replace the drawer by locating it on the side runners and pushing in.

Electrical Connection

The cooker must be installed by a qualiﬁed electrician, in accordance with all relevant British Standards/Codes of Practice (in particular BS 7671), or with the relevant national and local regulations.

WARNING: THE APPLIANCE MUST BE EARTHED.

Note: The cooker must be connected to the correct electrical supply as stated on the voltage label on the cooker, through a suitable cooker control unit incorporating a double pole switch, having a contact separation of at least 3mm in all poles.

The cooker must not be connected to an ordinary domestic power point.

Access to the mains terminal is gained by removing the electrical terminal cover box on the back panel. Connect the mains cable to the correct terminals for your electrical supply type (Fig.7-11and Fig.7-12). Check that the links are correctly ﬁtted and that the terminal screws are tight. Secure the mains cable using the cable clamp.

Fig.7-11

�

��

ArtNo.130-0010 Electrical connections single-phase

��

Fig.7-12

��

�

��

��	��
	��
	��

��

��ArtNo.130-0010 Electrical connections 3-phase

��

Fig.7-13

Hob Check

Check each cooking zone in turn. Be sure to use pans of the correct size and material.

ArtNo.000-0006 - Securing the 110 plinth

Grill Check

Turn on the grill control and check that the grill heats up.

Oven Check

Set the clock as described earlier, and then turn on the ovens.

Check the oven fans start to turn and that the ovens heat up.

Fitting the Plinth

Loosen the three screws along the front bottom edge of the cooker. Hook the central keyhole over the central screw. Twist and ﬁt each end keyhole over their respective screws. Tighten the ﬁxing screws (Fig.7-13).

Please complete your contact details in the front of this section. Please inform the user how to operate the cooker and hand over the instruction pack.

Rangemaster U109948 - 04 Electrical Connection, Hob Check, Grill Check, Oven Check, Thank you

Models: U109948 - 04