Rangemaster U109948 - 04 manual To Adjust an Oven Door Catch Keep, To Replace an Oven Door Seal

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

14.To Change the Oven Door Latch

Remove the outer door panel (see 13). Remove screws ‘B’ that hold the latch assembly to the inner door panel (Fig.8-7). Fit the new catch and reassemble in reverse order.

Verify the door operation.

15.To Adjust an Oven Door Catch Keep

Open the oven door, and slacken off the locknut at the base of the keep (Fig.8-8).

Screw in or out as required until the required fit is obtained. Retighten the locking nut.

16.To Replace an Oven Door Seal

Fig.8-7 ArtNo.320-0004 Oven Fig.8-8

�

ArtNo.320-0003 Oven door latch

Fig.8-9

Open the oven door. The seal has small hooks that hold it in place by locating into holes in the rear door face on the main oven and oven front face on tall oven. At the corner, pull the seal diagonally away from the door centre until the hook is released (Fig.8-9). Proceed to the next hook and release it in a similar way, and so on.

You can use force if the hooks are stiff, as the old seal will be discarded.

Carefully lift away the inner back. Reassemble in reverse order making sure that the four screws and washers are fully tightened.

ArtNo.320-0005 Oven door rubber seal

17.To Remove an Oven Element Thermal Cut-out

Disconnect from electricity supply.

Pull the cooker forward to gain access to the cover box. Undo the cover screws and lift clear. The cut-out is located on the earth plate beside the oven element connections. Disconnect the cut-out wiring. Undo the fixings that secure the cut-out to the earth plate and remove. Fit the replacement control and re-assemble in reverse order.

18.To Remove an Oven Inner Back

Disconnect from electricity supply.

Open the door and remove the shelves. Remove the screws and washers securing the inner back to the back of the oven (Fig.8-10). Carefully lift away the inner back. Reassemble in reverse order making sure that the screws and washers are fully tightened.

19.To Remove the Fan Oven Element

Disconnect from electricity supply.

Remove the oven inner back (see 18). Remove the two screws from the top of the element and the one from the bottom of the element inside the oven (Fig.8-11).

Lift the element out carefully, disconnecting the terminals connected to the element (noting their positions).

If it is not possible to disconnect the leads in this way, pull the cooker forward to gain access to the rear.

Remove the screws securing the electric cover to the back sheet, remove the cover and disconnect the terminals from the rear.

Fig.8-10

ArtNo.320-0020 Oven back fixing screws

Fig.8-11

��������������������

ArtNo.321-0005 Fan oven element

25