Rangemaster U109952 - 02 manual To Replace an Oven Door,  The door is heavy, so take care

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

Fig.8-2 Fig.8-3

�	�
ArtNo.320-0001 Door hinges	ArtNo.320-0001 Door hinge

Fig.8-4

ArtNo.320-0006 Oven door hinge adjustment 1

Effect of hinge adjustment - exagerrated for clarity

9.To Replace an Oven Door

Open the oven door. Support the door and remove the two screws securing the upper hinge and gasket to the cooker front (Fig.8-2).Remove the door from the lower hinge by lifting slightly and moving outwards (Fig.8-3).

 The door is heavy, so take care.

Reassemble in reverse order.

10.To Adjust an Oven Door Angle

The bottom hinge of either oven door can be adjusted to alter the angle of the door (Fig.8-4). Loosen the bottom hinge fixing screws and use the notch and a flat bladed screwdriver to move the position of the hinge to set the hinge position (Fig.8-5).

Retighten the hinge screws.

11.To Replace the Main Oven Door Outer Panel

Move the cooker forward to gain access to the sides.

Open the oven door slightly and remove the front panel fixing screws from the door sides – two each side (Fig.8-6).

Carefully lift off the outer door panel.

Remove the door handle from the panel by unscrewing the two retaining nuts. Fit the door handle to the new panel.

Fig.8-5

Centreline of hinge pin

ArtNo.320-0007 Oven door hinge adjustment 2

Oven door omitted for clarity

Fit the panel to the door. Reassemble in reverse order.

12.To Replace the Tall Oven Door Outer Panel

Remove the oven door (see 9). Lay the door face down on a suitable surface and remove the two screws from the bottom edge of the door and the two screws from the inside face of the door.

Remove the outer door panel. Remove the handle by unscrewing the two screws.

Unscrew the two cross-headed screws holding the door handle fixing bracket to the door panel. Fit the door handle bracket and door handle to the new panel.

Fig.8-6

ArtNo.320-0002a Proplus oven door side screws

Fig.8-7

�

ArtNo.320-0003 Oven door latch

Fit the panel to the door and reassemble in the reverse order.

13.To Change the Main Oven Door Latch

Remove the outer door panel (see 11). Remove screws ‘B’ that hold the latch assembly to the inner door panel (Fig.8-7). Fit the new catch and reassemble in reverse order.

Verify the door operation.

14.To Adjust the Main Oven Door Catch Keep

Open the oven door, and slacken off the locknut at the base of the keep (Fig.8-8).

Screw in or out as required until the required fit is obtained. Retighten the locking nut.

15.To Replace the Tall oven Magnetic Latch

Remove the control panel (see 1). Remove the plinth

(3 screws) and the central vertical cover (5 screws). Prise the retaining clip off the magnet unit.

Fit the new unit and retaining clip, and reassemble in reverse order. Check that the door operates correctly.

24