PART ONE
OWNER'SOPERATINGINSTRUCTIONS
FOR YOUR SAFETY - READ BEFORE OPERATING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
SECTION 1 - START-UP PROCEDURES
Your Raypak Pool/Spa heater has been designed for years of safe and reliable pool/spa water heating. It is available in millivolt or electronic control options. ASME certified units, typical used in commercial applications, are also available. This manual provides operation, installation, maintenance, and service information for these heaters.
ON
OFF
Fig.# 9472
If your heater has been installed correctly, operating the heater is an easy task. The upper front panel of the heater contains the control center that allows you to turn the heater on or off and adjust the temperature settings for the pool or spa. The temperature range is factory set from 65°F (18°C) to 104°F (40°C). The heater is also equipped with a toggle switch to turn the heater on and off, see fig. # 9472 above for location. Section 4 of this manual contains more details about the use of the controls in the Controls Adjustments subsection (page 29).
BEFORE START-UP
BURNERS |
| WATER |
Clean main burners, combustion fan and air louvers of |
| Water must be flowing through the heater during opera- |
dust, lint and debris. Keep heater area clear and free from | tion. Insure that system is filled with water and have pump | |
combustibles, flammable liquids and chemicals. Do not | operating. | |
obstruct the flow of combustion and ventilating air. |
|
Fig.# 9478
RP2100 DIGITAL IID POLYMER
4