Razor 13111290 owner manual Before You Begin, Estimated Assembly and Set-Up Time, Required Tools

Before You Begin

Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.

MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.

Estimated Assembly and Set-Up Time

Razor recommends assembly by an adult with experience in bicycle mechanics. Allow up to 20 minutes for assembly, not including initial charge time.

Allow up to 12 hours for initial charge (see page 4 for charging information)

Charger

(Note: Charger design may varyBrake Lever from one shown)

Charger	Twist Grip Throttle
Port
Charger
Plug
	Handlebar
	Stem
	Push Button

Spark Bar	Quick Release
	On/Off switch
	Reset Button
	Charger Port

Limiter

Spark Cartridge

Motor

-Battery

-Control Module

Required Tools

5mm Allen wrench	8mm, 10mm, 13mm and	Phillips	Bicycle-style tire pump
(Included)	16mm open wrenches	Screwdriver	for Schrader valve tires,
	(Not Included)	(Not Included)	with pressure gauge
			(Not included)

WARNING: DO NOT USE NON- RAZOR PRODUCTS WITH YOUR RAZOR ELECTRIC SCOOTER. The scooter has been built to certain Razor design specifications. The original equipment supplied at the time of sale was selected on the basis of its compatibility with the frame, fork and all other parts. Certain aftermarket products may not be compatible and will void the warranty.

Note: Electric scooter must be moving at 3mph/5km while twisting the throttle to engage motor.

Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.

3