Razor 13111290 owner manual Assembly and Set-Up, Attaching the Handlebars, Inflating the Tire

Assembly and Set-Up

qAttaching the Handlebars

(a)

1 Open the quick release.	2 Depress the push button (a)	3 Adjust the tension of the
	located on the front fork and in-	quick release to where you can
	sert the handlebar stem until the	close the lever all the way to
	bottom of the handlebar stem	secure the stem.
	locks securely onto the fork.

qInflating the Tire

The front tire is inflated when shipped but it invariably may lose some pressure between the point of manufacturing and your purchase.

1 Using a bicycle style tire pump equipped for a Schrader- type valve, inflate the front tire to the correct PSI indicated on the sidewall of the tire.

qCharging the Battery

Your electric scooter may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.

• Initial charge time: 12 hours	• Run time: Up to 40 minutes of continuous ride time.
• Recharge time: up to 12 hours, depending on level	Run time may vary depending on riding conditions,
of depletion and even if the light turns green.	climate and/or proper maintenance.
• Fully charge battery before storing.	• Average battery life: 250 charge/discharge cycles
• When the scooter is not in regular use, recharge	• To ensure long battery life, do not store the battery
the battery at least once a month until normal	in temperatures above 75° or below -10° F.
use is resumed.
Charger

Note: Make sure power is
turned OFF when unit is not in	1 Plug the charger into a wall	2 Turn power OFF before
use. If the power switch is left
on for an extended period of	outlet. If the lights on charger	charging. Plug the charger into
time, the battery may reach a	do not light up, check the power	the charger port to charge unit.
stage at which it will no longer	to the outlet. If necessary, try a
hold a charge.	different outlet.

Note: Make sure the cables/ wires are out of the way before inserting the stem into the fork.

Note: The pressurized air supplies found at gasoline stations are designed to inflate high-volume automobile tires. If you decide to use such an air supply to inflate the tire, first make sure the pressure gauge is working, then use very short bursts to inflate to the correct PSI. If you inadvertently over-inflate the tire, release the excess pressure immediately.

WARNING: Failure to recharge the battery at least once a month may result in

a battery that will no longer accept a charge.

WARNING: Rechargeable batteries are only to be charged under adult supervision. Always disconnect your scooter from the charger before cleaning with liquid.

Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.

The charger has a small window with one LED to indicate the charge status. Refer to the illustration on the charger unit for the actual “charging” and “charged” status indications for your model charger.

Chargers have built-in over-charge protection to prevent battery from being over-charged.

Charger will get warm during use. This is normal for some chargers and is no cause for concern. If your charger does not get warm during use, it does not mean that it is not working properly.

4