Razor 25117460 owner manual Assembly And Set-Up, Charging the Battery, Attaching the Handlebars

• Recharge time: Always remember to turn the power switch off and recharge for at least 8 hours after each use. When vehicle is not in regular use, recharge battery at least once a month until normal use is resumed. If you have left the power switch on or your product has not been charged for a long period of time the battery may reach a stage at which it will no longer hold a charge.

ASSEMBLY AND SET-UP

Charging the Battery

Your electric four wheeler may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.

• Initial charge time: 12 hours

• Run time: up to 40 minutes

• Average battery life: 250 charge/discharge cycles

WARNING:

Always disconnect your electric four wheeler from the charger before cleaning with liquid.

Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.

Charger

Plug

Charger Port

The charger has a small window with one LED or two LEDs to indicate the charge status. Refer to the illustration on the charger unit for the actual “charging” and “charged” status indications for your model charger.

Chargers have built-in over-charge protection to prevent battery from being over-charged.

1 Align the groove on the plug	2 Plug the charger plug into a
of the charger port and plug	wall outlet.
into the port on the Dirt Quad.
Tighten the threads to secure
the plug. The charger works
with the power switch in either
the on or off position.
Attaching the Handlebars

Be sure to properly align the groove on the charger input port with the corresponding socket on the Dirt Quad and tighten threads; otherwise, no charging action will occur.

WARNING:

Failing to properly adjust and tighten the bolts that affix the handlebars can cause you to lose control and crash.

1 Using the 6mm hexagonal key wrench, remove bolts from handlebar clamp.

2Place handlebars in handle- bar clamp in upright, vertical position.

3Insert bolts and tighten securely. When properly tightened, the handlebars should not move forward or back. Note: The gap between the upper clamp and lower clamp should be equal on both sides of handlebar.

3