REPAIR AND MAINTENANCE
q Replacing the Fuse
WARNING:
To prevent shock or short circuit, please follow the instructions accordingly and do not skip or combine any steps.
1Make sure the power switch is turned off.
Amperage number
4 Remove the fuse and replace with a new one of equal amperage.
Note: Amperage rating is located on top of fuse. Fuse must be replaced with one of equal amperage.
2Under the front fender and through the frame, locate the fuse cover attached to the top of the battery casing.
5 Close the fuse cover.
3 Open the fuse cover to expose the fuse.
q Replacing the Chain
Tools required: 6mm hexagonal key wrench, 10mm wrench and Phillips screwdriver.
1 Remove the bolt on the | 2 Remove the bolt on the | 3 Remove the 3 screws from |
outside of the rear wheel. | inside of the rear wheel. | the top half of the chain guard |
| Remove nut and pull bolt out | and remove from frame. |
| of axle. |
|
4 Remove the 2 screws from | 5 Spread the chain tensioner | 6 Remove chain from both |
the bottom half of the chain | apart to loosen chain. | sprockets and replace with new |
guard and remove from frame. |
| chain. |
|
| 5 |
WARNING:
Do not touch motor after use. Motor is (or can be) very hot.