Specifications
Model: |
|
Frequency Response: | |
Amplifier Power: | 100 Watts |
Woofer: | 10” Compressed Cellulose Composite Woofer |
Crossover Frequencies: | |
Dimensions: | 13”H x 14½”W x 14½”D |
Weight: | 30 lbs. |
|
|
Troubleshooting
Situation: | Probable Cause: | Solution: |
No sound from | Amplifier is not connected | Make certain the amplifier is |
subwoofer(s) | to constant power outlet. | plugged into an unswitchable |
|
| A.C. power outlet. |
| Amplifier is not receiving an | Make certain there is an audio |
| audio signal from receiver | signal from receiver or proces- |
| or processor | sor and audio connections |
|
| resemble those in the connec- |
|
| tions section of this manual. |
| Amplifier fuse might be | Replace fuse (if fuse is not |
| blown. | readily accessible, consult your |
|
| authorized RBH dealer). |
Performance is | The + and - polarity of the | Check the entire system for |
less than | subwoofer wire might be | proper polarity. Experiment |
expected | reversed on the subwoofer. | with the phase switch. |
| Crossover frequency not | Adjust crossover frequency |
| adjusted correctly. | by turning the crossover fre- |
|
| quency control clockwise until |
|
| desired sound is obtained. |
|
|
|
| L/R line level input is con- | If bass management is enabled |
| nected instead of the LFE | on receiver or processor make |
| line level input.. | sure to use the LFE line level |
|
| input. (See amplifier controls |
|
| and setup on previous page.) |