ASSEMBLY
TRAILER HITCH (FIG. 4)
Fig. 4
Proceed to the following steps:
1.Remove two bolts from the grass collector support plate on the rear side of the tractor.
2.Place trailer hitch in place.
3.Replace bolts, washers and nuts. Tighten securely.
GRASS COLLECTOR BAG (FIG. 5)
Fig. 5
The grass collector has been
1.Take the
2.Put the grass container, prepared in such a way, on the basket supports on the rear part of the tractor and adjust with the fenders. Tighten the bolts (item 2) properly.
3.Stretch the bag (item 3) with your hand and put it on the rear handle, with the inlet hole of the basket upwards. Insert the bottom tube (item 9) into the bag, unscrew the nuts M5 of the bolts (item 10) under the basket cover and insert the corner supports (item 8) under the tubes at the top, screw on the nuts M5 on the bolts (item 10) and (item 4) and tighten, loosely.
4.Tilt the left and right supports (item 5). Put in place the lower brace (item 7) from the outside of the grass collector bag and secure them with screw (item 6) loosely.
5.Place the grass collector, hinge it on the tractor supports and check the fit between the grass collector cover and fenders. With a regard of the loose screws you can adjust the fit between the cover and fenders.
6.If it is not possible, with the help of the method above, to accomplish the correct fit between the tube frame and the tractor rear adjust, move the supports on the tractor by moving them up or down.
7.Remove the grass collector, tighten all screws securely and fix the grass collector bag to the tube frame with plastic clips.
8.Slip the dumping lever (item 12) through the hole of the collector cover and tube frame, secure it with screws M5x 12 and nuts MS (the nuts are located inside the tube).
NOTE: After assembling check all the screws and nuts for tightening.
4 – English
