Chapter 1: Connections & Setup

Things to Consider Before You Connect

Protect Against Power Surges

¥Connect all components before you plug any of their power cords into the wall outlet.

¥Turn off the TV and/or component before you connect or disconnect any cables.

¥Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions packed separately.

Protect Components from Overheating

¥DonÕt block ventilation holes on any of the components. Arrange the components so that air can circulate freely.

¥DonÕt stack components.

¥If you place components in a stand, make sure you allow adequate ventilation.

¥If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it wonÕt flow around other components.

Position Cables Properly to Avoid Audio Interference

¥Insert each cable firmly into the designated jack.

¥If you place components above the TV, route all cables down the side of the back of the TV instead of straight down the middle of the TV.

¥If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cables away from audio/video cables.

Important Stand and Base Safety Information

Choose the location for your TV carefully. Place the TV on a stand or base that is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safety Instructions packed separately.

Use Indirect Light

DonÕt place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.

Cables Needed to Connect Components to Your TV

The pictures below show the cables needed for the connection represented in this book.

Coaxial cable

S-Video cable

Audio/Video cables

Component Video (Y, Pb, Pr) cables

Alert Guard Antenna

The picture to the left shows the Alert Guard antenna packed with your TV, specifically designed for the Alert Guard feature. Connect the antenna to the EXT Alert Guard ANT jack on the back of the TV (go to page 8 for more information). DonÕt connect the antenna to the regular TV ANT jack on the back of the TV.

Alert Guard Antenna

Chapter 1

Graphics contained within this publication are for representation only.

3

Page 7
Image 7
RCA 27V570T, 24F670T, 27F670T, 32F670T manual Things to Consider Before You Connect, Chapter