RCA BLD-6HD1 instruction manual 200-240V, 50/60Hz, Back view of your VCR

Put the batteries into the remote control. Make sure the (+) and (-) signs on the batteries agree with the (+) and (-) signs in the battery compartment.

Setting up your video (Option 1) - Connecting your video through RF lead

Setting up your video (Option 2) - Connecting your video through RCA lead

1	Before you start, unplug all the equipment from the mains supply.
	Television
	200-240V, 50/60Hz

Back view of your VCR
AUDIO	ANT. IN
AUDIO	VIDEO
R L
L	OUT

2

Switch off all components when connecting or disconnecting cables.

200-240V, 50/60Hz

AUDIO	ANT. IN
AUDIO	VIDEO
R	L
L	OUT
	ANT. OUT
R	IN

	ANT. OUT
R	IN

This lead is supplied in your accessory kit.

If you have connected your video as shown in option 1, turn to page 6.

Aerial

The type of aerial you should use, depends on local interference and how far you are from the transmitter. You should contact a local retailer if you have any questions about your aerial.

◆Unplug the aerial cable from your TV and plug it into the "ANT. IN" socket of the video.

Plug the short coaxial cable provided into the "ANT.OUT" socket of the video and the aerial socket of the TV.

◆Plug a RCA cable into the "RCA” socket of the video and the AV socket on the TV if available.

This connection will provide best picture and sound quality. Ask your dealer for an appropriate cable if you do not have one.

Without a RCA cable, you need to follow the steps described under "If you are not using a RCA cable" (See page 4)

◆Make sure the rating of the household mains supply matches the rating shown on the back of the video.

Now plug in the mains lead. The display of the video should now light.

◆Plug a phone cable into “Audio L, R” jack on the rear panel and into the Audio jack on any audio amplifier, if needed.

2 3