RCA F19426 manual Important Note When code testing is

Connections & Setup

3. Highlight the channel to which you have to tune your TV in order to see cable programming, and press OK (a screen appears reminding you to connect your G- LINK cable to your TV and cable box).

Note: Channel 03 is the most common.

4. Highlight your brand of cable box, and press OK.

If your brand isn’t listed, highlight Not Listed and press OK.

	5. Make sure your cable box is on.
	Tune the cable box to channel 02 (use the remote
	control that came with your cable box, or press the
	channel buttons on the cable box).
	Press OK (the GUIDE Plus+ system starts testing
	codes).
	Important Note: When code testing is in
	progress, don’t touch your TV, VCR, cable box or
	any of the remote controls for these products.
	6. Look at your cable box. If it is still on and changed to
	channel 09, the test was successful. Highlight Yes, and
	press OK (STEP 3: Configuring for a VCR appears).
	If your cable box didn’t change to channel 09 or
	turned itself off, you have two choices: No and Test
	this code again.
	Test this code again: If you think the TV, the cable
	box, or any of the remote controls might have been
	touched or bumped during the test, highlight Test this
	code again and press OK (the GUIDE Plus+ system
	runs the same set of codes).
	No: If you don’t think the test was interrupted,
	highlight No and press OK (GUIDE Plus+ system tests
	the next code).
	Repeat the previous instructions until the TV finds the
	correct cable box code. Follow the instructions on the
	screen.
	Note: If the TV can’t find your cable box code,
	a troubleshooting checklist appears. Carefully
	review each checklist and follow the
	instructions on the screen.
Chapter 1	17

15720240.01 Setup 17 4/9/02, 1:00 PM