26
• The cordless handset may be out of range of the base.
Move closer to the base.
• Charge the battery.
Unit beeps
• Clean charging contacts on cordless handset and charge
cradle with a soft cloth or an eraser.
• See solutions for “No dial tone” on previous page.
• Replace the battery.
Memory Dialing doesn’t work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and no communication between the base
and cordless handset
• Unplug the AC power adaptor from the wall outlet and
the back of the base, and remove the backup batteries
from the bottom of base (if previously installed).
Remove the handset battery. Wait for 30 seconds and
plug the power adaptor back into the base and wall
out, and re-install batteries in the base unit. Reconnect
the handset battery and charge for 12 hours.
Caller ID Solutions
No Display
• Is battery fully charged? Try replacing the battery.
• Make sure that the unit is connected to a non-switched
electrical outlet. Disconnect the AC power supply from
the base and reconnect it.
Caller ID Error Message
• The unit displays this message if it detects anything
other than valid Caller ID information during the silent
period after the first ring. This message indicates the
presence of
noise on the line.
No Caller ID
• In order to receive Caller ID information, you must
subscribe to the standard name/number Caller ID
service from your local telephone company.
Battery Solutions
If you experience any of the following problems, even
after fully recharging the battery, you may need to
replace the battery pack:
• Short talk time
• Poor sound quality
• Limited range
Other Information