RCA HDLP61 manual How to Connect TV + Satellite Receiver + VCR

Connections & Setup

TV

Satellite Receiver

VCR

VCR

VIDEO	L	AUDIO	R
ANTENNA IN
OUT
VIDEO	L	AUDIO	R
IN
ANTENNA OUT

SATELLITE

RECEIVER

VIDEO L AUDI R S-VIDEO

OR

OFF-AIR ANTENNA

3

RIGHT

LEFT

FIXED/VARIABLE

TV

AUDIO

OUTPUT

CENTER CHANNEL INPUT

SPEAKER

INTERNAL

EXTERNAL AMPLIFIER

MAXIMUM POWER RATING!

SELECT

SPEAKER

(60 WATTS into 8 OHMS)

INT W/

R

SOURCE

EXT

EXT

TV

EXT AMP

SURR

EXTERNAL SPEAKERS

L

VIDEO

VIDEO

VIDEO

VIDEO

INPUT 1

INPUT 2

INPUT 3

INPUT 4

V

V

V

PR

V

PR

VIDEO

INPUT 5

S-VIDEO

S-VIDEO

DVI-HDTV

2A

L/MONO

L/MONO

L/MONO

PB

L/MONO

PB

L/MONO

RAUDIO

RAUDIO

RAUDIO

Y

RAUDIO

Y

RAUDIO

INPUT 1

INPUT 2

INPUT 3

INPUT 4

INPUT 5

RECORD

OUTPUT

VIDEO

ANTENNA B

ANTENNA A

INPUT

INPUT

AUDIO

DIGITAL

AUDIO

ETHERNET

R

OUTPUT

2B

L

G-LINK

CABLE

1

Connect G-LINK Cable (see page 23)

How to Connect: TV + Satellite Receiver + VCR

1.Connect your cable or off-air signal to ANTENNA A.

If you have cable and an off-air antenna, connect the cable signal to ANTENNA A INPUT (antenna A is the only source for the GUIDE Plus+ system). Connect the off-air antenna to ANTENNA B INPUT. If you have only an off-air antenna, connect it to ANTENNA A INPUT.

2.Connect your VCR to your TV.

A.Connect the VCR’s audio/video outputs to INPUT 1 (audio/video) on the TV using composite audio/video cables.

B.Connect the VCR’s audio/video inputs to RECORD OUTPUT on the TV. This enables recording of digital programs (unless copy protected, using DVI HDTV or component video formats), as well as analog programs.

3.Connect your Satellite Receiver to your TV.

Connect the satellite receiver’s audio/video output jacks to the INPUT 2 AUDIO (R and L) and VIDEO jacks on the TV using composite cables. If your satellite receiver has an S-Video output, you can make the video connection by using the S-VIDEO jacks instead. If your satellite receiver has component outputs, then use INPUT 3 or 4.

Note: If you are using an S-Video cable or component video cables, you must also use audio cables. The S-Video cable and component video cables only transfer video information.

Viewing the Components

1.Turn on the TV and the component(s) you want to view.

2.Press the TV button on the remote control.

3.Press the INPUT button on the remote control to scroll through the Video Input Channels.

•The VCR can be viewed on the INPUT 1 channel.

•The satellite receiver can be viewed on the INPUT 2 channel.

Note: You can set up the TV to automatically tune to the correct Video Input Channel. This is called Auto Tuning. (See Chapter 3 for more information.)

Go to page 23

Chapter 1 11