RCA L40HD33D How to Use Remote After Programming It, Using Manual Code Search, Modes of Operation

Note: The remote control may not be compatible with all brands and models of devices.

Using Manual Code Search

Note: Before using manual code search, you must use Direct Entry first. This lets the remote know which type of device should begin searching codes. Then proceed with the following steps.

1.Turn on the device you want to control.

2.On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons (approximately 3 seconds) until the CANCEL button lights up. Then release the buttons.

3.Press and release the device button (SAT/AUX or DVD) you want to program.

4.Repeatedly press and release the left arrow or right arrow button, watching for the device to respond. If it does turn off, press and release the OK button to save the code. The CANCEL button will long blink to indicate success.

5.When all codes have been searched, the CANCEL button will short blink to indicate fail,

then the remote returns to normal operation.

Note: Use right arrow to search ahead, use left arrow to search back. Or you can press the ON/

OFF button to switch to Auto Code Search mode.

Using Automatic Code Search

1.Turn on the device you want to control.

2.On your remote control, simultaneously press and hold the ON•OFF and MUTE (approximately 3 seconds) buttons until the CANCEL button lights up. Then release the buttons.

3.Press and release the device button you want to program.

4.Press and release the ON•OFF button once. The remote starts the code search.

5.Once the device turns off, quickly press the OK button to save the code. The CANCEL button will long blink to indicate success.

6.When all codes have been searched, the CANCEL button will short blink to indicate fail, then the remote returns to normal operation.

Note: If you accidentally passed the code before saving it, press the left arrow button to backtrack through the codes; then use the right arrow button to go forward through the codes again. Once the left arrow or right arrow button has been pressed, the search mode changes to Manual Code Search.

How to Use Remote After Programming It

Once the remote has been programmed successfully, it is ready to operate your devices. To operate a device:

To operate the device:

1.Press the appropriate device button (SAT/AUX or DVD) to set the remote to control the device, for example, press DVD to control your DVD player.

2.Press ON•OFF to turn the device ON or OFF.

3.Use the remote buttons that apply to that device.

Modes of Operation

The button corresponding to the mode the remote is in lights up when you press any button that works in that mode. For example, if you’re in TV mode and you press the VOL+ button, the TV button lights up. This tells you that the command to increase the volume is being sent to the TV (and not the satellite receiver, for example).

26

Chapter 2 Using the remote control