The CUSTOM button allows you to store favorite TV channels in memory You can nels using the remote’s number buttons. below to program channels to each of the
10 of your
access these chan- Follow the steps number buttons.
Programming | the | Custom Button | PRESS | q | ; |
|
|
| &HOLD | + | . |
1. Press and hold CUSTOM. |
| CUSTOM |
| ||
|
|
| |||
|
|
|
| 0 |
|
2. Press the number |
|
|
| ||
to use to bring up the custom |
|
|
| ||
channel. For example, if you |
|
|
| ||
want to program channel 12 to |
|
|
| ||
the number 1 button, press 1. |
|
|
| ||
3. Enter the channel number as you |
|
|
| ||
would normally. Up to three but- |
|
|
| ||
tons may be pressed, including |
|
|
| ||
the ENTER button. |
|
|
| ||
4. Release CUSTOM. The Custom |
|
|
| ||
button will flash once if pro- |
|
|
| ||
gramming | was successful. |
| CUSTOM | - | |
If it does not flash, it was not |
| ||||
|
|
| |||
programmed. | Try again. |
|
|
| |
5.Repeat steps
Using the CUSTOM feature
1.Press and release CUSTOM.
2.Press a number button to bring up the Custom channel pro- grammed. Custom will flash if the button has been programmed. There will be a slight delay as channels change, so be sure to hold the number button down until the channel changes.
3.The CHANNEL UP or DOWN keys can now be used to cycle through all programmed number buttons while in the Custom mode.
To Turn off the Custom Feature Press any device button (TV,
VCR, CABLE, AUX) to exit
the remote from the Custom
mode and place it in normal
operating mode.
CUSTOM
:’
5
i,
;:
CHAN
$
AUX CABLE “CR TV
0000
14
