RCA RCU900 warranty Smart Macro Key Operations, Program a Smart Macro

RCU900_IB_revC.qxp 12/3/02 9:45 Page 19

4.All Learned command entries are now cleared for all device modes.

5.Press LCD CLEAR on the Main Setup Screen to exit Setup Mode.

Smart Macro Key Operations

Your RCU900’s Smart Macro feature allows you to execute a sequence of commands with one keypress. A Smart Macro learns any sequence of original remote commands. A total of 20 Learned commands can be stored under each of the nine available LCD MACRO keys. The sequence of commands you want a Smart Macro to execute must be programmed in correct sequential order. Any sequence of commands that you regularly perform can be stored as a Smart Macro and reduced to a single keypress. You cannot program a Macro within a Macro.

Program a Smart Macro

Example of Programming a Macro

1.Turn on the TV and set it to channel 3.

2.Turn on the satellite receiver and set it to channel 57.

3.Turn on the VCR.

4.Now you’re ready to record your favorite satellite program with just a press of a button.

To program a Smart Macro, follow these steps:

1.Gather all your original remotes that contain functions you would like to add to a Smart Macro.

2.Place the first original remote in the Learning position. Point the top of the original remote at the base of the RCU900 so the IR LED on the original remote is in line with the RCU900 Learning sensor, located at the bottom of the remote. The remotes should be positioned two to three inches apart.

3.Press and hold the SETUP key on the rubber keypad until the LED indicator light remains on and the touchscreen shows the Main Setup Screen. This process takes approximately 2-3 seconds.

4.Release the SETUP key.

5.Press and release the LCD MACRO key. The LED indicator light blinks once to indicate acceptance of

the keypress.

6.The touchscreen now shows the Macro Setup Screen 1. Press and release the digit key under which you want to store the Smart Macro (from 1-9). The LED indicator light blinks once to indicate acceptance of the keypress.

7.The touchscreen now shows the Macro Setup Screen 2. Press and release the LCD LEARN KEY?. The LED indicator light blinks once to indicate acceptance of the keypress.

19