RS2654_EN(Canada) 2/7/06 3:28 PM Page 20
Troubleshooting Tips
Maintenance
EN
Problem | Solution | Problem | Solution | ||
System will | • | Check power cord for a secure | CD sound | • | Clean the disc. |
not turn |
| connection. | skips | • Check disc for warping, | |
on | • | Unplug the unit for a moment, |
|
| scratches, or other damage. |
|
| and then plug into power |
| • Check if something is causing | |
|
| source again. |
|
| the system to vibrate. If so, |
| • Check the outlet by plugging in |
|
| move the system. | |
|
| another device. |
| • Make sure the speakers are | |
|
|
|
|
| at least 3 feet away or on a |
No sound | • | Increase the volume setting. |
|
| different surface from the |
| • Check connection to speakers. |
|
| main unit. | |
| • Check that you have selected |
|
|
| |
|
| the appropriate function: CD, | CD button | • Switch to another function | |
|
| Tuner. | will not |
| (Tuner) and then back to CD. |
| • Make sure mute is off. | respond, or |
|
| |
| • Make sure headphones are not | does not |
|
| |
|
| plugged in. | change |
|
|
|
|
| discs when |
|
|
Poor radio | • | Check antenna connection. | you press |
|
|
reception | • | Move antenna. | DISC SKIP |
|
|
| • Turn off nearby electrical |
|
|
| |
|
| appliances, such as hair dryer, | Remote | • Check that the batteries are | |
|
| vacuum cleaner, microwave, | control |
| properly installed. |
|
| fluorescent lights. | does not | • | Replace weak batteries. |
|
|
| work | • Check the system is plugged | |
CD does | • | Check that CD is in the tray. |
|
| into power source. |
not play | • | Check that CD label is facing |
| • Point the remote directly at | |
|
| up. |
|
| the system’s front panel. |
| • Check that PAUSE mode is not |
| • Move closer to the system. | ||
|
| on. |
| • | Remove any obstacles |
| • Check that CD function is |
|
| between the remote and the | |
|
| selected. |
|
| system. |
| • Use CD lens cleaner. |
|
|
| |
| • | Clean the disc. |
|
|
|
| • | Try another CD. |
|
|
|
Disconnect the audio system from the power source before performing any maintenance.
Cleaning
Clean the exterior of the system using a soft dust cloth.
CD Player
CAUTION! This system operates with a laser. It must be opened by only a qualified technician.
Handling CDs
•Do not touch the signal surfaces. Hold CDs by the edges, or by one edge and the hole.
•Do not affix labels or adhesive tapes to the label surfaces.
•Do not scratch or damage the label.
CDs rotate at high speeds inside the player.
•Do not use damaged (cracked or warped) CDs
Cleaning CDs
•Dirty CDs can cause poor sound quality. Always keep CDs clean by wiping them gently with a soft cloth from the inner edge toward the outer perimeter.
•If a CD becomes dirty, wet a soft cloth in water, wring it out well, wipe the dirt away gently, and then remove any water drops with a dry cloth.
•Do not use record cleaning sprays or antistatic agents on CDs. Also, never clean CDs with benzene, thinner, or other volatile solvents which may cause damage to disc surface
CD Lens Care | EN |
When your CD lens gets dirty it can also cause the system to output poor sound quality. To clean the lens you will need to purchase a CD lens cleaner which can maintain the output sound quality of your system. For instructions on cleaning the CD lens, refer to the ones accompanying the lens cleaner.
Technical Specification
Power supply: 120V~60Hz Dimensions ( H x W x D inches): Unit size - 12.3 x 12 x 15.9 Speaker - 13 x 9.4 x 8.1
CD player: Response curve (+/- 2dB): 60Hz to 5kHz
Rating Plate: Look for it at the back of the set.
14 |
|
|
| 15 |
|
|
|
|
|
