Getting Started
Test Tone / Channel balance
Channel balance
Your receiver is equipped with a test signal generator for balancing the channels. As the signal "travels" from chan- nel to channel, adjust the level controls until each channel plays at the same loudness level. (details see operation of test/setup)
Connecting for Power
Make sure you connect all your other
electronic components and theEN speakers before plugging your
receiver into the outlet. Plug the power cord in the wall outlet, matching the wide blade of the plug with the wide slot in the outlet. Be sure to insert the plug completely.
Courtesy Dolby Laboratories
Level adjustment & surround channel level expectation
Even though you adjust the surround channel to be as loud as the others on the test signal, you'll find that on actual program material the surround channel is usually much lower than the front. Don't be tempted to readjust the sur- round level; program producers use surround mostly for subtle atmosphereics and ambience, and only rarely for special effects. A good surround mix doesn't call attention to itself; if it did, it would soon become distracting.
NOTE
The system is equipped with Dolby Digital, and manufactured under License from Dolby Laboratories.
Dolby Digital Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic”, “Pro Logic II”
and the
Using Headphones
To listen privately through your audio system, use the PHONES jack on the receiver. However, make sure you turn down the volume before you put on the headphones. Increase the volume to the desired level after headphones are in place.
Once headphones are connected, “HEADPHONE DOWNMIX 2 CHANNEL” will scroll on display. This feature automatical- ly converts
Hearing Comfort & Well-Being
•Do not play your headset at a high volume. Hearing experts advise against continuous extended play.
•If you experience a ringing in your ears, reduce volume or discontinue use.
Factory Setting
The RTDVD1 is preset to the following setting when you first turn on the power
Source = DVD/CD Volume setting = 45 dB
Bass & Treble = 0 dB
Restore to Factory Settings
You can always restore all settings back to its original state. When the receiver is in STANDBY mode, press accordingly on the main unit to restore all settings back to factory
default : |
|
|
PRESET - | PRESET + | BASS/TREBLE |
NOTE
All preset radio stations and surround sound set- ting will be lost after factory setting is restored.
9
