RCA scenium TV turns on unexpectedly, Video and audio are out of sync, Blank screen, References

References

TV turns on unexpectedly

•Record/Wake Timer feature may have been activated. Go to page 66 for instructions.

•Initial Channel feature us enabled and you lost power to your TV. Go to page 62 for instructions.

Video and audio are out of sync

•If you’ve connected a component, such as a DVD player, to your TV’s Video jack, and to an audio receiver using the audio jacks, you may experience a slight delay between the audio heard and the video seen. Connect the DVD player to the TV’s Audio jacks, then use the TV’s FIXED/VARIABLE AUDIO OUTPUT jacks to connect to an audio receiver.

If your TV is connected to an audio/video (A/V) receiver or home theatre system via the DIGITAL AUDIO OUT jack, read the following information.

•If you’ve connected a component to your A/V receiver, such as a DVD player or satellite receiver, you may experience a slight delay between the audio heard and the video seen. This occurs because the digital audio is sent directly to the speakers while the video must be processed inside the TV before it is displayed.

•If the component has Component Video (Y, Pb, Pr) jacks, connect these jacks to the TV’s Y, Pb, Pr jacks to minimize the discrepancy. This works best if the component supports Progressive Scan technology.

•If necessary, you can connect the component directly to the TV using L/R audio jacks and bypassing the A/V receiver or you can program an audio delay in the A/V receiver so the audio and video match up (not all audio equipment has the ability to program delays). Check the audio/video Receiver’s manual.

Blank screen

•Make sure you have connected the component to the TV correctly.

•Make sure the component connected to the TV is turned on and tuned to the corresponding Video Input Channel.

•Try another channel, or press the INPUT or ANT•CAB button.

•When you first turn off your TV, the screen fades from blue to black. Once the screen goes black, the TV’s internal lamp starts its cool-down cycle. If you try to turn on the TV during the cool-down cycle, the TV turns back on and you’ll hear audio, but the picture will take a few moments to be displayed.

•If you’re trying to play a DTVLink Recording, you may have accessed an “unrecorded” subchannel. Press the CH+ or CH- buttons to go through the subchannels before you get to the subchannel you recorded. This occurs even when you’ve selected to record only a specific subchannel because of how digital (ATSC) channels are broadcast and recorded by your DTVLink component—the data for the subchannel is recorded, but not the content.

Unusual sound quality

•Check the Graphic Equalizer, SRS, and Sound Logic settings.

•Check if SAP is turned on.

•Check that the Audio Mode is set to your language.

Humming or buzzing noise

•The TV is in its lamp cool-down cycle. To prolong the life of the TV’s lamp system, the TV must warm up and cool down properly. You may notice additional noise during these cycles.

•Maybe the speakers are turned off. Check the FIXED/VARIABLE OUT control panel in the Audio menu.

No picture, sound okay

•If the indicator on the front of the TV is blinking, the lamp inside of your TV may need to be changed. Go to page 79 for ordering information.

•You might have tried to turn on the TV during lamp cool-down. Wait a few moments and the picture will be displayed.

Chapter 5 71