mounting instructions
(Continued from previous page)
c)Insert the four selected screws through each hole from the inside of the cabinet going down (see Figure 5).
Figure 5
d)Hold each screw head down and push the unit and spacers onto the screws, then hold the unit up until spacers are firmly against the bottom of the cabinet (and fully nested within each other if you are using multiple spacers for each screw).
e)Partially tighten each screw, but do not fully tighten the screws until all of them have been started (see Figure 6).
| Cabinet |
| Bottom |
Cabinet |
|
Overhang | Spacers |
Equal to or | Minimum |
Longer than |
|
Cabinet |
|
Overhang |
|
Figure 6
f)Gently tighten each screw until they are firmly holding the unit in place. The top front edge of the unit should clear the overhang.
CAUTION
To reduce the risk of fire, do not place any heating or cooking apparatus beneath this unit.
Mounting Suggestions
1)If your cabinet has obstructions inside it which prevent you from using the template, cut out the corresponding area on the template, but do NOT cut out or through the screw holes.
2)If your cabinet has obstructions underneath it, which will interfere with the mounting of the unit, remove the obstruction before mounting the unit, or find another location to mount the unit.
3)It is recommended that you wear safety glasses while drilling to prevent eye injuries.
4)For wood cabinets, you may want to mark the hole locations with a nail, pressed gently but firmly into the wood so that a slight impression is made. This will also help keep the drill bit centered in the right location.
5)Hold the drill firmly against the cabinet to keep the drill from “walking”.
11
RCA SPS36073 English IB W012 OK.indd 12
8/21/2009 4:47:45 PM 
