4. INSTALLATION
“Installation”menu helps you to setup a variety of parameters necessary for receiving signal, add new service, upgrade the new software and reset the channel data.
Select“Installation”menu in main menu, and you will be asked to enter your PIN code.
You can find the following“Installation”screen by entering it.
4.A. ANTENNA SETUP
Your receiver includes the preprogrammed information of transponders contained in various satellites.
You can update the transponder list preprogrammed for a satellite by adding a new transponder to it or modifying the information of the existing transponder. (Refer to the Channel Scan described in section 4.B) Select“Antenna Setup”menu in“Installation”menu and the following screen will be displayed.
Select the desired satellite using the“left/right” keys(◀∙▶).Set“LNB Power”“, LNB Type”“, LNB Freq”“, 22KHz”,“Search Option”, and“DiSEqC 1.0” fields to the appropriate value using the left/right keys(◀∙▶) at each field.
LNB Power | : Depending on the user’s antenna LNB, you can supply either LNB power by |
LNB Type | setting“ON”or not by setting“OFF”. Normally set this to“ON”. |
: You can select the LNB type. | |
LNB Freq. | : You can select the predefined LNB frequency or manually enter a specific |
| frequency in MHz unit by pressing numeric keys. |
22KHz | : In case you are using two antennas connected to a 22KHz tone switch box, |
| you can supply either 22KHz by setting“ON”or off by setting“OFF”to select |
| antenna. |
Search option | : You can search all the free channels & scramble channels or only free channels |
| or onlyscramble channels by setting the search option. |
DiSEqC 1.0 | : If you have DiSEqC box, you can choose port by selecting port number. |
Motor | Otherwise, choose“none”. |
: If you have a DiSEqC 1.2 motorised system, then you can takeadvantage of the | |
| DiSEqC 1.2 functions available. Choose Installer as Motor and press “F1” key. |
| After that, adjust antenna direction using browse keys. |
|
|
4. A. 1 Automatic Scan
Check the signal strength. Press“OK”key to start the scan procedure.You can see the progressive status of channel searching.
Please note that the scan procedure may take a few minutes. Press the“menu”key or“exit”key to return to previous menu.
4. A. 2 Blind Scan
Blind Scan search the channel when you don’t know the transponder information.
Press the F2 key to start the blind scan procedure and the following screen will be displayed.
Please note that the scan procedure may take a few minutes.
Press the “menu” key or “exit” key to return to previous menu.
18
MENU OPERATION
MENU OPERATION |
|
| 19 |
|
|
|
|