RCA WHP140 warranty Troubleshooting, Problem Solution

TROUBLESHOOTING

If you encounter any trouble in setting up the Headphones, please check the following points:

PROBLEM	SOLUTION
Distorted sound	A)	Check if the sound of your audio source is
quality or		distorted and whether the volume control
unclear sound:		is set to an adequate level.
	B)	Make sure that your audio equipment, the
		transmitter and headphones are connected
		properly and switched ON. If the batteries
		in the headphones have insufficient power,
		replace them with fresh batteries.
	C)	Check if you have selected the best channel.
		Adjust the Channel Tuning once again to
		check. If necessary, you may change the
		setting of the transmitter by turning the
		CHANNEL TUNING THUMBWHEEL up
		or down, then adjusting the thumbwheel
		on the HEADPHONES to tune in a better
		channel setting to improve audio or
		eliminate interference.
No sound from	A)	Check if the batteries are inserted properly
the headphones:		into the battery compartment and whether
		the headphones are switched ON.
	B)	Check if the batteries in the headphones
		have sufficient power—replace them
		if necessary.
	c)	Check if the transmitter is properly
		connected and powered on with the AC/
		DC Adapter (the Power LED
		Indicator should glow RED).
	D)	Check if all the cords are properly connected.
	E)	Check if the distance between the
		headphones and transmitter are within the
		effective range. (The effective range of the
		device is approx. 100 feet). Move closer to
		the transmitter to receive the sound.
Mono sound:	A)	Check if the audio source is mono only,
		use a stereo audio source.

10