EQUALIZER SWITCH

The DSP power makes it possible to equalise the audio signal; this function has been implemented in a totally independent way from the feedback suppression.

•SPEECH: The frequency response of the radiomicrophone is perfectly flat.This selection is recommended for speech only.

•MUSIC: In this position, thanks to the DSP processing, middle, mid-bass and bass tones are appropriately emphasised to make the microphone sound warmer, mellow and “round”; the voice takes on fullness and presence, so this option is particularly suitable to sing.

TRANSMITTER / HAND-HELD MICROPHONE TX 1000

TRANSMITTER / HAND-HELD MICROPHONE EQUIPPED WITH:

•Electret cardioid microphone.

•ON/OFF switch for the transmitter.

•MUTE switch.

•LED indicating the battery charge status.

USE:

•(!) Make sure the power switch is in the OFF position before inserting the batteries.

•To access the battery compartment, remove the cover by pressing the button and turning

the cover outwards at the same time.

•Insert a 9 V alkaline battery according to the polarity indications (+/-) printed on the bottom and put the cover back on.

•Turn on the transmitter using the switch on the battery cover: the red LED should stay lit only for a few seconds; if it stays lit longer, the battery is very low and should be replaced.

•Make sure the MUTE switch (on the upper part, near the mic. capsule) is set to MIC.

•Check the transmitter is working correctly: one of the two green LEDs A/B on the respective receiver should be lit.

ENGLISH

23