ENGLISH

ENGLISH

BELT-CLIP TRANSMITTER PX 1000

BELT-CLIP TRANSMITTER EQUIPPED WITH:

•ON/OFF switch for transmitter activation.

•MUTE switch.

•A green LED indicating the battery charge status.

•A trimmer to adjust the input sensitivity.

•A red“PEAK” LED

(indicating the maximum admissible level of the input signal).

•A socket with screw-lock connector for the microphone.

USE:

•(!) Make sure the power switch is in the OFF position before inserting the battery.

•Connect a clip-on (“Lavalier”) mic. LA 1000 or a headworn mic. HE 1002 by inserting the mini-jack into the transmitter socket and tightening it thoroughly.

•Remove the cover of the battery compartment using a coin or a screwdriver.

•Insert a 9 V alkaline battery according to the polarity indications (+/-) printed on the bottom.

•Put the cover back on the battery compartment and press it down to secure it in its seat.

•Switch on the transmitter by setting the ON/OFF switch to ON.The green LED lights up (the LED stays lit during normal operation; it flashes when the battery is low and should be replaced).

•Make sure the MUTE switch is set to ON.

•Check the transmitter is working correctly: one of the two green LEDs A/B on the respective receiver should be lit.

•Adjust the input sensitivity appropriately (using a screwdriver) using the SENS trimmer located on the upper part of the transmitter (during normal use, increase the sensitivity so the red “PEAK” LED flashes occasionally but does not remain lit continuously).

24