Operation
WARNING
•The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts.
NOTE
•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.
6.When the engine has started, move the choke lever gradually downward to open the choke.
7.Allow the engine to warm up for a half minute before starting operation.
NOTE
1.When restarting the engine immediately after stopping it, leave the choke open.
2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.
■STOPPING ENGINE
1.Release the throttle lever and run the engine for a half minute.
2.Shift the ignition switch to the STOP position.
NOTE
•Except for an emergency, avoid stopping the engine while pulling the throttle lever.
■ADJUSTING IDLING SPEED
1.When the engine tends stop frequently at idling mode, turn the adjusting screw clockwise.
2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw
NOTE
•Warm up the engine before adjusting the idling speed.
■LINE HEAD USAGE 
WARNING
1.Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.
2. Keep the debris guard attached in place at all times when the unit is operated.
TRIMMING GRASS AND WEEDS
•Always remember that the TIP of the line does cutting. You will achieve better results by not crowding the line into the cutting area. Allow the unit to trim at its own pace.
1.Hold the unit so the head is off the ground and is tilted about 20 degrees toward the sweep direction.
