English
8. Operation
exhaust port.
F11 | (1) |
|
F12 [EBZ8001]
(1)
F13 [EBZ8001RH]
(1)
F14
(1)
(2)
(3)
6.Once the engine is running, gradually open the choke if it was set closed, and let the engine run at idle speed for a minute to warm it up.
NOTE
When the engine fails to start after several attempts due to overchoking, open the choke and repeat pulling the rope.
■ADJUSTING IDLE SPEED (F11)
•The idling speed is set for 2000 rpm at the factory. If it is necessary to adjust the idle speed, use the adjustment screw on the top side of carburetor.
(1) Idling Adjustment Screw
■STOPPING ENGINE
[EBZ8001]
• Move the throttle lever to the idling position and press the stop switch (red button). The machine has the mechanism that once the stop button is pushed the plug won't give off sparks until the engine stops. (F12)
(1) Stop Switch
[EBZ8001RH]
•Move the throttle lever to the idling position and set the ignition switch to the stop position. (F13)
(1) Ignition Switch
NOTE
If the engine won’t stop when setting the ignition switch to the stop position, close the choke lever and stop the engine.
In this case, please repair the machine at your nealest servicing dealer. (F14)
(1)Choke Lever
(2)OPEN
(3)CLOSE
32
