Redring manual HOW TO USE YOUR ACTIVE 320S SHOWER DETAILED

IF WATER IS TOO HOT

Turn inner knob “B” anti-clockwisein the direction of the “blue arrows” to “11 o’clock” and continue turning anti-clockwise until you get the water temperature of your liking.

Wait 20 seconds after each adjustment for the water temperature to stabilise.

If after turning fully anti-clockwise, water is still too hot, adjust outer knob “A” to

“ (medium)” setting and re-adjust as above. Water flow will be reduced on this setting.

9. Isolate the mains electrical and water supply before removing the front cover of the appliance.

HOW TO USE YOUR ACTIVE 320S SHOWER (DETAILED)

1.Ensure the electricity and water are turned on to the unit.

2.Your shower has 3 power settings selected by turning outer knob “A”.

The most popular is “ (high)”.

There are also options for a “ (medium)” or “ (cold)” shower (see notes 8 and 9).

For this example turn outer knob “A” to “ (high) ” and set inner knob “B” to “12 o’clock”.

3.The water will flow and the neon light will glow brightly.

4.Allow about 20 seconds for the temperature of the water to stabilise.

IF WATER IS TOO COLD

Turn inner knob “B” clockwise in the direction of the “red arrows” to “1 o’clock” and continue turning clockwise until you get the water temperature of your liking.

Wait 20 seconds after each adjustment for the water temperature to stablise.

5. Once a temperature setting to your liking has been achieved, inner knob “B” will rarely need adjusting. You must however take into account required adjustments for variations of incoming mains water temperature

between summer and winter (see “Effect of Seasonal Incoming Water Temperature Changes”).

6.When you have finished showering, turn outer knob “A” anti-clockwise to the “ (stop)” position. Water will continue to flow for up to 3 seconds before switching off. This reduces the temperature of the water in the tank for the next user.

Switch off the electricity at the ceiling switch or local isolator.

7.The “ (medium)” setting of outer knob “A” reduces the power used by the shower giving a cooler shower or the option of reduced water flow. This option is mainly used for summer usage and if this is used then inner knob “B” must be re-adjusted.

8.The “ (cold)” setting of outer knob “A” will supply water without any heating, and the neon light will go out.

9.Your shower is designed to stabilise temperature changes caused by water pressure fluctuations (see “Effect of Other Water Devices on Incoming Water Supply”).

10.Note that inner knob “B” IS NOT A TAP and does not turn the water off.

WARNING: DO NOT SWITCH THE SHOWER ON IF YOU SUSPECT IT OF BEING FROZEN. WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT.

WARNING: DO NOT OPERATE THE SHOWER IF WATER LEAKS FROM THE PRESSURE RELIEF VALVE. MAINTENANCE IS REQUIRED BEFORE THE SHOWER CAN BE SAFELY USED.

3