The model and serial number are located on the bottom face of the shower.
Make a note of those numbers here, and be sure to quote them if you call for advice.
Model Number:
Serial Number: _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
HOW TO INSTALL YOUR EXPRESSIONS 500S SHOWER
WARNING: ALL WIRING AND INSTALLATION MUST BE
SUPERVISED BY A SUITABLY QUALIFIED PERSON.
WARNING: DO NOT INSTALL THIS SHOWER WHERE IT MAY BE
SUBJECTED TO FREEZING CONDITIONS
We recommend that the installation is done in the following sequence. a. Fixing the shower to the wall b. Plumbing c. Electrical connections
a.FIXING THE SHOWER TO THE WALL
1.Position the riser rail at the height recommended in diagram 5 and mark its position (also see separate accessories fitting instructions).
2.Position the heater so that the top of the unit is horizontal and level with, or a maximum of 0.6 metres (2ft) below the top of the riser rail. Choose a flat piece of wall to avoid the possibility of distorting the backplate thus making the front cover a poor fit.
3.Adjust the position to get the most convenient arrangement taking the following into account.
∙The possible need to use the handset over the sink for hair washing etc.
∙The heater must not be mounted in the direct spray from the handset.
∙The handset must not be able to come into contact with used water in the cubicle, bath or basin. If it can, even after the hose has been retained by the soap dish (see separate accessories fitting instructions sheet) then a vacuum breaker must be fitted.
4.Fix the riser rail with screws provided (see separate instructions supplied with accessories).
5.Decide the position of the electrical cable into the unit. If top or bottom entry is chosen (according to diagram 4), cut away the walls in the backplate as shown in diagram 6.
7
