Redring 500S manual Warning Do Not Fit A Tap On The Shower Outlet

7.The shower is designed to have an open outlet and should only be used with ”Redring” recommended fittings.

Do not connect the handset until after the shower front cover and corner section are fitted.

WARNING: DO NOT FIT A TAP ON THE SHOWER OUTLET.

WARNING: TAKE CARE TO AVOID RESTRICTING THE OUTLET OF THE PRESSURE RELIEF DEVICE

c)ELECTRICAL

WARNING: THIS SHOWER MUST BE EARTHED.

The electrical installation must be in accordance with the current BS.7671 (IEE Wiring Regulations) and “Part P” of the Building Regulations and/or local regulations

1.The SHOWER is designed for a single phase AC electrical supply.

Please check the rating plate on the unit to see what details apply to your unit.

AS A GUIDE ONLY (* Only applies if external earth impedance is less than 0.35 Ohms)

Rating	Cable Sizes	Fuse / MCB	Cable Length
	4.0mm²	32A Type B MCB	21m Max.
	6.0mm²		35m Max.
7.2 / 6.6kW 240 / 230V
	6.0mm²	40A Type B MCB	27m Max.
	10.0mm²		45m Max.
	6.0mm²	40A Type B MCB	27m Max.
	10.0mm²		45m Max.
8.5 / 7.8kW 240 / 230V
	6.0mm²	45A BS.1361 fuse	12m Max.*
	10.0mm²		21m Max.*
	6.0mm²	40A Type B MCB	27m Max.
	10.0mm²		45m Max.
9.5 / 8.7kW 240 / 230V
	6.0mm²	45A BS.1361 fuse	12m Max.*
	10.0mm²		21m Max.*
10.5 / 9.6kW 240 / 230V	10.0mm²	45A BS.1361 fuse	12m Max.*

Remember to upgrade the cable if it runs in thermal insulation in a loft, or for a longer distance.

2.A means for disconnection in all poles must be incorporated in the fixed wiring in accordance with the wiring rules.

We recommend a ceiling switch mounted in a convenient position.

3.Cut back cable as in diagram 7. Connect cable to terminal block making sure that all the retaining screws are VERY TIGHT and that no cable insulation is trapped under the screws.

WARNING: FAILURE TO COMPLY WITH THESE

INSTRUCTIONS COULD RESULT IN

FAILURE OF THE TERMINAL BLOCK

4. Re-Fit the corner section back into the backplate.

9