| Top Fixing Holes | |
Diagram 2 |
| |
| Motor | |
PCB Enclosure | Terminal | |
| Block | |
| Rating Plate | |
Commissioning | Position | |
Cable | ||
Link | ||
| Clamp | |
| Pump Assy | |
| Cold Inlet | |
| Port | |
Solenoid | Hot Inlet | |
Port | ||
| ||
Bottom Fixing | Side Section | |
Holes | ||
| ||
| Filter | |
| Housing | |
Outlet | Mixer | |
| ||
| Chamber | |
|
|
The limiter is factory set but can be adjusted to suit on site conditions. If the position of the limiter requires adjustment please refer to the section in the commissioning procedure (page 9).
8.To override the stop position of the limiter, press the button on Knob 'B' and continue turning Knob 'B'
9.If the temperature limiter has been overridden, knob 'B' MUST always be returned to the normal temperature range when the shower is
switched off. To do this, simply turn knob 'B' clockwise past the limiter position. The button does not need to be depressed when returning to the normal temperature range.
10.There are 4 defined spray settings provided by the handset (See diagram 3).
The ring can be turned in either direction to change the spray pattern.
a) Spray: | Powerful fine jets. |
b)Massage: Sparkling pulsating massage.
c)Champagne: Soft, aerated, relaxing spray.
d)Pulse Mix: Massage/Spray Combination.
a) | c) |
b) | d) |
Ring
Diagram 3
3
