Redring 600, 620 manual What to do if things go wrong

Check the spray plate is then free to rotate to give the three settings.

In some winter conditions, when the incoming mains water is particularly cold it may be necessary to select the inner or outer spray pattern only. This will ensure correct operation of the shower with a slightly lower water flow rate

Note: After use it is normal for some water to drip from the showerhead for a few moments, this inhibits scale build up over prolonged use.

What to do if things go wrong

SELF HELP

If the shower is unsatisfactory, make the following checks before calling out the contractor. Any of these adjustments could restore the performance

	Increase water flow by adjusting the
a) Water too HOT	temperature control clockwise.
	Clean spray plate holes. (Select outer or
	combination spray patterns).
	Switch power to MEDIUM setting.
	Increase pressure of water supply e.g. fully
	open service valve or stop cock. Check hose is
	not kinked restricting the water flow.
	Decrease water flow by adjusting the
b) Water too COLD	temperature control anti-clockwise.
	Select inner or outer spray patterns only.
	Switch power to HIGH setting.
c) Spray pattern poor	Clean spray plate and flush heater. (Select
	inner / outer spray pattern).
	Check water pressure has not fallen so far as
d) Water goes cold while using shower	to let pressure switch cut out, e.g. another tap
	drawing water off.
	Raise position of handset.
	Please contact our spares department on
e) Broken parts	0870 0102 829.
	Fitting instructions are provided with spares.
PROFESSIONAL SERVICE

If the previous checks fail to restore the performance, you should either contact the Redring Technical Advisory Service or seek the assistance of a qualified plumber and / or electrician.

The person who installed the shower is probably the best one to repair it and is certainly the person to contact if you have a problem in the guarantee period.

The following additional checklist is provided for the benefit of the qualified serviceman.

WARNING – SWITCH OFF THE ELECTRICITY AT THE ISOLATING SWITCH BEFORE REMOVING THE COVER TO MAKE CHECKS.

5