Reebok Fitness RBEX31080, CYC4 manual Washers may be pre-attached to the Seat

4.Attach the Handlebar (7) to the Handlebar Post (6) with three M8 x 20mm Button Screws (19) and three M8 Flat Washers (18). Make sure to thread the Upper Wire Harness (16) and the Pulse Wires (22) through the indicated hole in the Handlebar.

5.The Console (9) requires two ÒAAÓ batteries (not included); alkaline batteries are recommended. Remove the battery cover from the back of the Console. Press two batteries into the battery clip as shown in the inset drawing. Make sure that the negative (Ð) ends of the batteries are touching the springs. Reattach the battery cover.

While another person holds the Console (9) near the Handlebar (7), connect the Pulse Wires (22) to the console wires. Next, plug the Upper Console Wire (16) into the socket in the back of the Console.

Insert all excess wiring down into the Handlebar Post (6). Attach the Console (9) to the Handlebar

(7) with four M4 x 10mm Screws (21).

6.Attach the Seat (12) to the Seat Post (11) with four M6 x 16mm Hex Screws (29) and four M8 Flat Washers (18). Note: The Hex Screws and Flat

Washers may be pre-attached to the Seat.

Using an adjustable wrench, remove the Seat Knob Assembly (31) from the Frame (1).

Insert the Seat Post (11) into the Frame (1). Slide the Round Collar (13) down the Seat Post and press it into the Frame. Secure the Round Collar to the Frame with a M6 x 10mm Screw (26).

Reinstall the Seat Knob Assembly (31) to the Frame

(1).

6

4
		Hole
	6	7
	18
19		16
	18
	19
5
	Console	9
	Wire
	22
7		Console
		Wire
		16
21		6
		Batteries	Battery
			Clip
6
		12
	11
	13
		18
	1	29
		26
		31