ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench 
and Phillips screw-
driver 
.
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 21. The number following the paren- theses is the quantity needed for assembly. Note: Some small parts may have been preattached. If a part is not in the parts bag, check to see if it has been preattached.
|
| M4 x 16mm |
|
|
M6 Washer | M8 Split | Round Head | M8 x 16mm Button | M8 x 19mm Button |
Washer | Screw | Screw | Screw | |
M6 x 42mm Button | M6 x 38mm Button | M8 x 50mm Button | ||
Screw | Screw |
| Screw | |
|
| M10 x 63mm Bolt Set |
| |
1.Orient the Left Front Stabilizer (15) with the Wheel (17) positioned as shown. Attach the Left Front Stabilizer to the left side of the Frame (1) with three M8 x 16mm Button Screws (54) and three M8 Split Washers (55).
Attach the Right Front Stabilizer (not shown) to the right side of the Frame (1) in the same way.
1 |
|
17 | 15 |
| 1 |
| 55 |
| 55 |
| 54 |
| 54 |
4
