ASSEMBLY
Assembling Fireplace
5
ASSEMBLY
WARNING: Always have branch support and screen in place before operating fireplace. This pre- vents excessive temperatures on fireplace surfaces.
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury.
ASSEMBLING FIREPLACE
Tools Required:
•Phillips screwdriver
•5/16" hex wrench
•slotted screwdriver
•scissors
1.Remove two screws that hold fireplace screen in place for ship- ping. These screws are located near top of screen. Discard screws. Lift fireplace screen up and pull out to remove. Set screen aside until installation has been completed.
2.Cut two plastic straps to remove the log from the firebox cavity.
3.An optional blower is available. See Accessories, pages 38 and 39. Install optional blower now. Follow installation instruc- tions provided with blower. See page 12 for
Shoulder
Screw
Screen
Burner Support With
Log Locator Tabs
Branch
Support
Figure 3 - Removing Screen
4.Locate four black phillips sheet metal screws from the hard- ware packet.
5.Rotate hood as shown in Figure 4. Make sure hood tabs point toward fireplace.
6.Insert hood tabs between baffle and louvers (see Figure 4).
7.Gently rotate hood to upright position. Make sure hood tabs are behind louvers and hood is resting on firebox top (see Figure 4).
8.Align screw holes on hood with screw holes on firebox top.
9.Insert screws as shown in Figure 4. Tighten screws firmly.
Hood Tabs
Hood Louver
Hood Tab
Baffle
Sheet Metal Screws | Firebox Top |
|
Figure 4 - Assembling Hood
For more
visit www.
.com
