2.Identify the Left Upright (73) and the Right Upright (74). See the inset drawing. Tie the wire tie in the Right Upright (74) securely around the end of the Upright Wire (75). With the help of a second person, hold the Right Upright near the Right Base Cover (77). Then, pull the other end of the wire tie up through the rectangular hole in the bottom of the Right Upright until the Upright Wire is routed completely through the Right Upright.
Gently pull up on the Upright Wire (75) as you set the Right Upright (74) on the Base (83) in- side the Right Base Cover (77). Be careful not to pinch the Upright Wire.
Attach the Right Upright (74) to the Base (83) with two 3/8" x 3 3/4" Bolts (72) and two 3/8" Star Washers (90). Do not tighten the Bolts yet. Note: It may be necessary to tip the top of the Right Upright forward slightly and rotate the bottom as you thread the Patch Bolts into the Right Upright.
Attach the Left Upright (73) to the Base (83) in the same way. Note: There are no wires on the left side.
With the help of a second person, lower the treadmill off the cardboard stand. Save the card- board stand for step 8.
3.Identify the Right Upright Sleeve (96) and the Left Upright Sleeve (95); the Sleeves are la- beled “Right” and “Left.” Slide the Right Upright Sleeve onto the Right Upright (74) and the Left Upright Sleeve onto the Left Upright (73).
2 |
|
|
|
|
|
| Wire |
|
|
| 73 | Tie | 75 |
|
|
|
| ||
|
|
|
| |
|
|
|
| 74 |
|
|
|
| 7783 |
|
|
|
| 90 |
74 |
|
|
| 72 |
75 |
|
|
| |
Wire Tie |
|
|
| |
3 |
|
| 95 |
|
| 73 |
|
| |
|
| “Left” | “Right” | |
|
|
| ||
|
|
|
| 96 |
|
|
|
| 74 |
7 |
|
|
|
|
