Gate Instructions

Important: Keep these instructions for future reference

Next, tighten the top 2 Adjustment Wheels by turning them counter-clockwise. Again, make sure both sides are equal as you tighten. As you tighten the Adjustment wheels you will notice the gap between the plastic gate door latch and the frame tube is narrowing. As the gap continues to narrow continue turning the upper Adjustment Wheels until the frame tube engages in the slot in the plastic gate door handle. Leave a 1/16” gap between the frame tube and the plastic gate door latch as shown in Diagram F. IMPORTANT: The frame tube MUST NOT touch the Plastic gate door latch. If it does touch you have turned the Adjustment Wheels a few too many turns. To correct this simply turn the upper Adjustment wheels clockwise a few turns until you have a 1/16th inch gap. Your gate is now ready to use.

1/16

Threaded Spindle Rod

Flat Plastic End

Adiustment

Wheel

Frame Tube

Diagram F .

(7)

Page 7
Image 7
Regalo Safety Gate installation instructions Diagram F