Regency I1100S installation manual Installation, Floor Protection, Firebrick Assembly, Door Handle

INSTALLATION

FLOOR PROTECTION

Please check to ensure that your floor protection and hearth will meet the standards for clearance to combustibles. Your hearth extension must be made from a non-combustible material.

FIREBRICK ASSEMBLY

Firebrick is included to extend the life of your insert and radiate heat more evenly. Check to see that all fi rebricks are in their correct posi- tions and have not become misaligned during shipping.

BRICK FLUE BAFFLE & SECONDARY AIR TUBE INSTALLATION

The fl ue baffl e system located in the upper area of the fi rebox is removable to make cleaning your chimney system easier. The brick baffl es must be installed prior to your fi rst fi re. Smoke spillage and draft problems may occur if the baffles are improperly positioned. Check the position of the brick baffl es on a regular basis as they can be dislodged if too much fuel is forced into the fi rebox.

The Large Insert I3100L is shipped with one of the secondary air tubes loose inside the fi rebox. It needs to be installed after the brick baffl e are installed. Follow the directions below.

Large Insert I3100L

3)Important: push both baffle bricks so they are tight against the side walls.

The unit arrives with the third air tube (from the front) and the 2 baffl e bricks on the fl oor of the fi rebox. The baffl e bricks are positioned fi rst and then the air tubes are installed.

Small Insert (I1100S)

1) Slide the left baffl e brick over the two rear air tubes and then push it all the way to the left side of the fi rebox.

Large Insert (I3100L)

Front View

4)Install the third air tube into the holes on the side channels. The notch goes on the right hand side with the air holes facing forward toward the door opening. If the tube will not slide in easily, simply use a pair of vise grips or pliers and tap it into place with a hammer. Atighter fi t will ensure the tube will not move when the unit is burning.

Hearth Heater (H2100M)

DOOR HANDLE

Attach spring handle by rotating counter clock- wise onto rod. Ensure that the rod fi ts into the entire length of the spring handle.

2)Tilt the fi rst Baffl e Brick down and then slide the 2nd Baffle Brick up and back. Reposition both baffl e bricks fl at on the air tubes.

Note: When cleaning the chimney reverse the above procedures, removing the air tube and baffle bricks and then replace them when cleaning is completed.

Regency Wood Insert & Hearth Heater 11