PREPARATION
Parts identification on assembled fan
Fan Housing
Blade
Blade Arm
Canopy
Downrod
Detachable Switch Housing
PREPARATION:
Verify that you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motor from packing. To avoid damage to finish, assemble motor on soft padded surface or use the original foam inset in motor box. Do not lay fan on its side as this could result in shifting of motor in decorative enclosure.
INSTALLING THE MOUNTING BRACKET
Caution: To avoid possible electrical shock, be sure electricity is turned off at the main power box before wiring. All wiring must be in accordance with National and Local Electrical Codes and the ceiling fan must be grounded as a precaution against possible electric shock.
1.Locate ceiling joist where fan is to be mounted, being sure location agrees with the requirements in the min- imum clearance section of this guide. Wood joist must be sound and of adequate size to support 35 lbs. (p. 1, #3 and #4)
2.If not already present, mount a UL listed outlet box marked “suitable for fan support” following the instructions provided with the outlet box. The outlet box must be able to support a minimum of 35 pounds.
3.Attach hanger bracket to outlet box using screws provided with the outlet box.*
Outlet Box
Screw
Ceiling Fan
Outlet Box
Hanger
Bracket
Flat Washer
Spring Washer
Washer Nut
*Parts other than hanger bracket are supplied with outlet box.
4