ASSEMBLY INSTRUCTIONS: DOWNROD, CANOPY, AND COLLAR COVER
1.Carefully support fan housing (motor) in its styrofoam packing with the mounting collar (where the wires come out) facing upward.
2.Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin; remove ball. The 6˝ downrod is recommended (if clearance above floor allows) to provide greater air flow, since more space will be available above the blades for supply air.
3.Feed the wires from top of fan through the end of the downrod you have selected, and set end of downrod into mounting collar so the hole in the downrod lines up with the hole in the side of the mounting collar.
4.Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in end of downrod pin to hold downrod pin in place.
5.Tighten security screws against downrod using a large flat blade screwdriver to ensure a tight fit against downrod. Then tighten lock nuts against mounting collar.
NOTE: Fan has 6 feet of
6.Feed wires through and slide collar cover down the downrod to top of fan.
7.Feed wires through canopy and slide canopy over downrod to lay on top of collar cover. It will be attached to ceiling later.
8.Feed wires through ball and slide ball over downrod, past hole in the top end of downrod. Insert ball pin (removed in Step 2), slide ball up and tighten set screw to secure ball in place.
9.Install 4 candelabra base bulbs (E12, 25w max) in sockets.
Hook-up Wires (3)
Ground
Wire
Ball
Canopy
Downrod
| Collar Cover |
Mounting Collar | Security Screws |
| |
Downrod | Cotter Pin |
Pin |
|
E12 bulbs
Fan
Housing
5