INSTALLATION
FACEPLATE & TRIM
INSTALLATION
1)Lay the faceplate panels flat, facedown on something soft so they don't scratch.
2)a) Take the top faceplate and align the holes in it with the holes in the side panels. Using the screws provided, attach from the top of the panel (holes in the top panel are slightly larger than the holes in the side panel to facilitate easier installation). See diagram 1.
b)4"(102mm) Hearth Trim. Attach the Hearth Trim to the bottom of the faceplate side panels with the screws provided. See diagram 1.
Hint: Don't tighten the screws down completely at this point, do a trial fit to the unit. Make any necessary adjustments and when it fits properly then tighten down the screws.
3)Using the trim clips provided, join the left side trim (with the ON/OFF switch) to the top trim. See diagram 2. Connect the right side trim to the top trim.
4)Place the trim on the assembled faceplate panels, aligning the wire connections from the switches with the notch on the left side panel.
5)Connect the fan switch wires by taking the black and red wires with the male ends (in the grey harness) and connect them with the 2 wire connectors from the fan speed control.
6)Connect the ON/OFF switch wires by taking the black and red wires with the female ends and connect them to the ON/OFF switch.
7)Install these wires in the clips on the left faceplate to ensure they don't touch the insert. See diagram 3.
8)The power cord should be run behind the faceplate panel from the U20/E21 to electrical outlet box.
9)Place top insulation in behind the top faceplate as in the diagram. Pressed securely into place.
Faceplate Assembly
Diagram 1
Trim
Clips
Trim Assembly
Diagram 2
| ON/OFF | |
| Switch | |
Wires to | Fan Speed | |
On/Off | Switch | |
Switch | (Rear View) | |
| ||
| Wire Clip | |
For Gas | Wires to | |
Fan Switch | ||
Connection | ||
Connectors | ||
|
POWER CORD (3ft) 
Diagram 3
10 | U20/E21 Gas Insert Zero Clearance Kit |
