Regency U37-NG1, U37-LP1 installation manual Glow on logs

INSTALLATION

9) Pull off the Hi/Lo gas extension knob to	12) Check that the screw is clean and if
access the orifi ce.	necessary remove dirt.

13) Flip the screw (Fig. 3).

16)Re-assemble the black protection cap (Fig. 6).

Fig. 6

17)Reverse steps 4 - 1.

10)Remove the black protection cap by hand from the hi-low knob (Fig.1).

Fig. 1

Fig.3

14) Using the Allen wrench as shown in Fig.4, rotate the screw clockwise until snug, do not overtighten.

Fig.4

WARNING!

Do not over tighten the screw. Recommended to

grip the wrench by the short side.

WARNING!

Also check that the pilot and main burner injectors are appropriate for the gas type.

18)	Attach the label "This unit has been
	converted to LPG" near or on top of the
	serial # decal.
19)	Replace yellow "NG" label with red
	"LPG" label.
20)	Check for gas leaks.
21)	Check inlet and outlet pressures.
22)	Check operation of fl ame control.

11) Insert a 5/32” or 4mm

Allen wrench into the

hexagonal key-way

of the screw (Fig.

15)Verify that if the conversion is from NG to LPG, the screw must be re-assem- bled with the red o-ring visible (Fig. 5).

23) Check for proper fl ame appearance and

glow on logs.

2), rotate it counter-

clockwise until it is free

and extract it.

Fig.2

Red o-ring visible

Fig.5

LPG Configuration

U37-1 Regency® ULTIMATE Rear Vent Direct Vent Freestanding Gas Stove 19