Regency U37-NG1, U37-LP1 Pins on Rear Log Support, lava rock, PinCutout, Notch Cutout

INSTALLATION

3)Place Rear Log A)02-65 on the two pins on the rear log support.

A)02-65

Pins on Rear Log Support

4)Place the Middle Left Log B)02-56 on the two pins as shown.

B)02-56

5)Sprinkle some lava rock just in front of B) 02-56 on the burner holes.

B)02-56

lava rock

7)Place the Left Top Log D)02-46 on the pin on Log B)02-56 and on top of the cutout on Log A)02-65.

A)02-65

D)02-46

B)02-56

C)02-44

PinCutout

8)Place Front Right Log E)02-45 on the two pins as shown.

E)02-45

9)Place the lava rock in the area between the left and right logs, leaving a space in the middle for log (F) 02-47.

11)Position notch in Front Right Log G)02-48 on Log F)02-47 and push the bottom right edge against the bracket on the burner tray.

G)02-48

A)02-65

	47
F)02	-	E)02-45

Notch

G)02-48

E)02-45

Side View

Bracket

The bottom right edge of Log G)02-48 must

sit snugly against the bracket

12)Test fi re to ensure proper light off (make sure fl ame fl ows smoothly from one end of burner to the other. If there is any fl ame hesitation, check that area for any blockage of the burner port.

	46			G)02	A)02-65
-
D)02				-
		-	47		48

6)Place Front Left Log C)02-44 onto the 2 10) Place the notch in Center Log F)02-47 over

front pins as shown.	Log E)02-45 and across the cutout on Log
	A)02-65.

F)02-47

C)02-44

E)02-45

Notch Cutout

B)02-56	F)02	E)02-45
C)02-44

U37-1 Regency® ULTIMATE Rear Vent Direct Vent Freestanding Gas Stove 21