TROUBLESHOOTING
PROBLEM |
| EXPLANATION |
Does | It may happen that, while filling the | |
steam go | tank, some water overfills the cap | |
out from | and flows inside the boiler wetting | |
the boiler? | the insulating material | |
Does the | 1) | While filling the tank you may |
nozzle or | have poured too much water into it. | |
gun leak |
|
|
water |
|
|
mixed with |
|
|
steam? |
|
|
There is | 1) | The steam knob (where |
no steam | supplied) might be closed | |
coming out |
|
|
of the | 2) | The foot pedal is not plugged in |
nozzle or | (i500B) | |
gun? |
|
|
| 3) | The boiler switch might be off |
| 4) | The water might be used up. |
Does the | Some dirty might have gone into | |
steam leak | the tank with the water and it is | |
dirty | given off from the iron. | |
water? |
|
|
SOLUTION
In order to solve the problem, we suggest using the machine as usual so that the insulating material dries up in about one hour through the heat of the machine. In case you still have this problem after one working hour, please contact the service centre.
1) The problem will go on until the excess water is emptied. Keep the steam button depressed until the water in the tank is at the correct level.
1)Open the steam knob anticlockwise.
2)Plug the
3)After the boiler switch comes on, wait for
10 minutes so the boiler produces steam.
4)Fill it following the instructions carefully. Fill the empty tank with 1 liter of water, screw the cap up, shake it, unscrew the cap and empty the tank. Repeat the action until the water is cleaned. We do not recommend the use of any additive to pour in the tank. Before ironing again spray some steam on a cloth until clean steam comes out.
