TROUBLESHOOTING
PROBLEM | EXPLANATION |
Does | It may happen that, while filling the |
steam go | tank, some water overfills the cap and |
out from | flows inside the boiler wetting the |
the boiler? | insulating material |
Does the | 1) While filling the tank you may have |
steam iron | poured too much water into it. |
leak steam |
|
mixed with |
|
water? |
|
| 2) The iron plate has to be hot before |
| the steam passage |
There is | 1) The steam knob (where supplied) |
no steam | might be closed |
coming out |
|
of the | 2) The iron switch might be off |
iron? |
|
| 3) The boiler switch might be off |
| 4) The water might be used up. |
Does the | 1) The ironing board cover might not |
ironing | be able to absorb the steam |
board get | completely |
wet? |
|
| 2) The steam iron leaks steam mixed |
| with water (Check by spraying some |
| steam on a dry cloth) |
Does the | Some dirty might have gone into the |
steam leak | tank with the water and it is given off |
dirty | from the iron. |
water? |
|
SOLUTION
In order to solve the problem, we suggest using the machine as usual so that the insulating material dries up in about one hour through the heat of the machine. In case you still have this problem after one working hour, please contact the service centre.
1) The problem will go on until the excess water is emptied. Keep the steam button depressed until the water in the tank is at the correct level.
2)Please check that the temperature knob is on the right position: “cotton °°°)”
1)Open the steam knob anticlockwise.
2)After the iron switch comes on, wait for 4 minutes so that the iron plate gets hot.
3)After the boiler switch comes on, wait for
10 minutes so the boiler produces steam.
4)Fill it following the instructions carefully.
1)You might use a thicker cover (or two covers) so to create a thicker surface to absorb the steam better. In case you are using a vacuum table, switch on the vacuum function each time you are using the steam
2)See # 2
Fill the empty tank with 1 liter of water, screw the cap up, shake it, unscrew the cap and empty the tank. Repeat the action until the water is cleaned. We do not recommend the use of any additive to pour in the tank. Before ironing again spray some steam on a cloth until clean steam comes out.