ASSEMBLY
Continued
Step ❸ Ð Attach Handle Bracket to
Pole Bracket
3A Slide handle bracket onto clamping bolt.
3B Clamping bolt should extend through handle bracket
Step ❹ Ð Secure Handle Bracket to
Pole Bracket
4A Place lockwasher onto clamping bolt.
| EN |
T | |
H |
|
G |
|
I |
|
T |
|
4B Thread knob onto clamping bolt. Note: After knob makes contact with handle bracket, tighten 1 1/2 to 2 more turns.
Step ❺ Ð Connect to Power Cord
5A Plug saw power cord into receptacle cord at end of inner pole.
OPERATING CHAIN SAW
WARNING: Read and understand this ownerÕsmanualbeforeoperatingthisPole Saw. Make certain you read and under- stand all Important Safety Information, pages 2 through 4. Improper use of this Pole Sawcancausesevereinjuryordeath fromÞre,electricalshock,orbodycontact with moving chain, or falling wood.
EXTENSION CORDS
Use proper extension cords with this Pole Saw. Use only extension cords marked for outdoor use. The cord must be marked with sufÞx W or
Cord Length | AWG Cord Size |
|
|
25 feet | 16 AWG |
50 feet | 16 AWG |
100 feet | 16 AWG |
150 feet | 14 AWG |
|
|
Keep cord away from cutting area. Make sure cord does not catch on branches or logs during cutting. Inspect cords often. Replace damaged cords.
The extension cord may come undone from the power cord during use. To avoid this, make a knot with the two cords as shown in Figure 5.
ADJUSTING POLE LENGTH
The Remington Pole Saw has a telescoping pole as- sembly that will extend from 57 inches (fully re- tracted) to 96 inches (fully extended). A cam levered collet is used to hold the pole in position at any ex- tended length.
1.To extend the pole, loosen the clamping lever as shown in Figure 6. Pole will slide freely.
2.Pull inner pole section out to desired length of extension. Note: Only extend pole to minimum length required to reach limb that is being cut.
3.To lock pole in position, tighten clamping lever as shown in Figure 6.
Continued
111219 | 15 | www.desatech.com |